[arriscad] Any luck with Polylines?

Jim Bennett jim.bennett at sigmadesign.com
Wed Aug 10 16:36:11 CDT 2011


Jeff,

By "abandoned boundary lines" do you mean the white boundary indicators 
that are used to place and edit? These can sometimes be left if the 
placement routine is improperly exited without finishing and the 
"Cancel" button is not used, or if an edit is improperly exited. If this 
is the case select the "Cancel" button on the Polylines Application 
Sub-menu and this should clear them (you may need to redisplay the 
screen). Be sure you are on the latest spin of ARRIS 9.4 as Polylines 
have been enhanced throughout the 9.4 release cycle.

I use Polylines all the time. They are great for showing electrical 
connections from switch to device (with the Spline feature On). Another 
good use that comes to mind is for contour lines.

Jim


On 8/10/2011 4:12 PM, Jeff George wrote:
>
> Is anyone out there consistently using Arris’ polylines without having 
> issues? I have been attempting to use them recently since I think they 
> would be beneficial in a lot of things we do. But.... in the little I 
> have used them, I somehow keep improperly exiting/editing a 
> boundary.... which is leaving the abandoned boundary lines visible on 
> my screen. ....and I have a difficult time making them go away.
>
> Anyone successfully using polylines?
>
> -----------------------------------------
>
> Jeff George
>
> *PTAC Consulting Engineers*
>
> 21 South Tarragona Street, Suite 101
>
> Pensacola, FL 32502
>
> Phone: (850) 432-8446
>
> Fax: (850) 432-9875
>
>
>
> _______________________________________________
> arriscad mailing list
> arriscad at lists.arriscad.com
> http://lists.arriscad.com/mailman/listinfo/arriscad

-- 
Jim Bennett, AIA
Product Director
Sigma Design
www.arriscad.com



More information about the arriscad mailing list