[arriscad] 45 degree X-hatch > locks ARRIS

[Steve Chizzo]

Arris 9.3

I have noticed this when my Arris window is not maximized on the screen
- otherwise it seems OK.

Sometimes I don't realize that the Arris window is just stretched out to
look like it but not actually maximized, and then it will happen......

If it happens during a normal, maximized session, perhaps it is a
resolution issue or other display setting?

 

Steve D. Chizzo, Architect

LEED AP

 

Ellis Stone Construction

ph:  715-345-5000

fx:   715-345-5007

www.ellisstone.com <blocked::http://www.ellisstone.com/> 

 

 

________________________________

From: arriscad-bounces at lists.arriscad.com
[mailto:arriscad-bounces at lists.arriscad.com] On Behalf Of Neal Logan
Sent: Monday, February 13, 2012 10:36 AM
To: arriscad at lists.arriscad.com
Subject: [arriscad] 45 degree X-hatch > locks ARRIS

 

Bug Report: HIGH PRIORITY

 

Please make a high priority the fix related to ARRIS locking up, and not
responding when X-hatch is selected with 45 degree lines. 

 

Even querying a pattern with 2-line at 45 and 135 degrees will cause
ARRIS to lock up, and become non-responsive.

 

In my particular example, this morning: I have imported a pre-cast
detail that has 2-line cross hatch representing insulation in the core
of a panel. Pick to match pattern and place new > ARRIS locks up,
luckily, AutoSave, has prevented losing 5 minutes of work, I may have to
set AutoSave feature to 1 minute.

 

Respectfully.

 

Neal Logan

Edward Farr Architects, Inc.
7710 Golden Triangle Drive
Eden Prairie,  MN 55344

Direct.  952-697-1083
Main:  952 943-9660  Fax. 952 943-9665

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman00.van.ca.siteprotect.com/pipermail/arriscad/attachments/20120213/b1caf0cf/attachment.html