[arriscad] Error $wlycre()

[Jim Bennett]

The error is coming from the utility that generates the display list on 
the layer. This is likely caused by a corrupted entity on the layer. If 
you can isolate which layer it is on, and which entity it is, you have a 
better chance of cleaning it up.

Try this:
At the keyboard type :dlof and <Enter>
Load the drawing
At the keyboard type :dlon and <Enter>
At the keyboard type :clr and <Enter>
At the keyboard type :dlcr and <Enter>

This will regenerate the display list and display to the screen as it is 
doing it. If it hits the entity giving the problem and stops, the stuff 
generated on the screen so far should tell you what layer it's on and 
possibly which entity.

For recovery the best case is if you can delete the entity and just 
replace it. If you know the layer the worst case is that you lose and 
replace only the stuff on that layer, or better, can recover just the 
layer from backup and update everything done since the backup on only 
that layer.

You mention AutoCAD not involved. Other likely suspects are very old 
ARRIS drawings, and particularly crosshatch and very small circle entities.

Jim


On 8/26/2011 11:41 AM, Jerry Anderson wrote:
>
> I am getting a Fatal Error “Unexpected System Error during call to 
> :$wlycre()”. Arris 9.2 Spin 108 Windows XP
>
> Is there a way to keep all my work or at least most of it. Autocad not 
> involved.
>
> Jerry
>
> Anderson Design & Consulting, Inc.
>
> 1233 Rhomberg Ave.
>
> Dubuque, IA 52001
>
> Phone: 563-582-7241
>
> Fax: 563-582-7243
>
> jla at qwestoffice.net
>
> THE INFORMATION CONTAINED IN THIS TRANSMISSION IS PRIVILEGED AND/OR 
> CONFIDENTIAL INFORMATION INTENDED FOR THE USE OF THE INDIVIDUAL OR 
> ENTITY NAMED ABOVE. IF THE READER OF THIS MESSAGE IS NOT THE INTENDED 
> RECIPIENT, YOU ARE HEREBY NOTIFIED THAT ANY DISSEMINATION, 
> DISTRIBUTION OR COPYING OF THIS COMMUNICATION IS STRICTLY PROHIBITED. 
> IF YOU HAVE RECEIVED THIS COMMUNICATION IN ERROR, PLEASE NOTIFY THE 
> SENDER IMMEDIATELY BY REPLYING TO THIS COMMUNICATION AND THEN DELETING 
> IT FROM YOU R SYSTEM. THANK YOU.
>
>
>
> _______________________________________________
> arriscad mailing list
> arriscad at lists.arriscad.com
> http://lists.arriscad.com/mailman/listinfo/arriscad

-- 
Jim Bennett, AIA
Product Director
Sigma Design
www.arriscad.com